Franklin Armory M4 Giveaway

One lucky reader—even from California!—will win this prize jam-packed with goodies every gun enthusiast needs! Leading off this massive package is the Franklin Armory M4 in .300 Blackout. The bolt carrier group, chamber, bore and barrel features a salt bath nitride finish. The M4 has a Double Heat Shield handguard with aluminum liners. It features a Carbine-length gas system and forged front sight gas block with an integral bayonet lug and front sling swivel. Its A4 upper receiver is forged from 7075-T6 aluminum, finished in hard coat type III anodized black and has a full Picatinny Rail. Its lower receiver offers a specialized tension screw and a Franklin Armory factory custom tuned trigger.

EOTech’s XPS2-300 sight offers a 2-dot ballistic drop reticle allowing zero for subsonic or supersonic rounds in the same reticle pattern. It mounts to a 1-inch Weaver or MIL-STD1913 rail, is repeatable to within 1 MOA when remounting and can run 600 continuous hours. It features a 65-MOA ring with two 1-MOA aiming dots.

The QTR-4 Hannibal knife is the perfect complement to your M4. Its 5-inch CPM 154 stainless steel blade has been carefully ground to keep much of the mass toward its tip, resulting in the smoothest operation imaginable when coupled with the ORB pivot system and tri-spoke pivot assembly. The finger guard plays double-duty as a flipper device.

Keeping your new M4 clean will be a breeze with the TekMat gun cleaning mat. Show your pride for your weapon while using this high-quality neoprene rubber backed and cloth top gun cleaning mat to protect your gun bench. The soft polyester top will ensure your gun doesn’t get scratched and keep harmful chemicals, oil and dirt from penetrating down to your bench. After the mat begins to accumulate too much dirt, chemicals or oil just throw it in the wash on a gentle cycle, allow to air dry and it will be virtually like new.

Stay in style with one of Disse Gear’s handcrafted Amerihide belts, which utilize two pieces of high quality leather, glued and stitched together using nylon thread. The finished belts are approximately .25-inch thick.

Olight covers your flashlight needs with the M18 Maverick shining 500 lumens from a compact, anodized, Milspec Type III aluminum body. The intuitive tailcap switch lets you choose between momentary- or constant-on while the side switch not only cycles through 3 output modes, but also glows red when it’s time to change the batteries. A contoured bezel provides an additional defensive tool, and with built-in memory and multiple ways to initiate strobe, the M18 makes an ideal EDC light. You can’t win if you don’t enter, so send those postcards in pronto or take the survey and enter online at GUNS Magazine Giveaway.

>> Click Here << To Read Details On Full Giveaway Package

>> Click Here << To Enter Giveaway Online

Leave a Reply

Your email address will not be published. Required fields are marked *

(Spamcheck Enabled)